Single Status Update
What does everyone use to fill kerf cuts? Im using sawdust and titebond but feel like it could use more.
- Show previous comments 2 more
I use PL 3x. If you wanna go full retard, you can glass over that as well.
titebond3 and fine sawdust. Mix it so its a bit thinner than peanut butter, but not so thin it runs. Once it hardens up which may take 24ish hours it should be solid. and if you have any resin and fiberglass cloth or mat you can do a layer over that, which really wouldnt cost much money or time if you had the materials on hand already.
I used plain old resin... if i did it again, i would use pl.