wafsman Posted June 25, 2011 Report Posted June 25, 2011 Was looking at the Precision Power S580.5 amp, running it in 3-ch, question is would I run into any problems with running a 3 ohm load on the two bridged channels?
wafsman Posted June 25, 2011 Author Report Posted June 25, 2011 If it helps, the reason why I ask is the amp says it has three modes of protection, one of them being impedance, wanting to make sure this will not cause problems if I run it bridged with a 3 ohm load.
SkylarDunn Posted June 25, 2011 Report Posted June 25, 2011 What do you mean running it in 3ch? why not get a 4 channel and bridge it? Getting bass into the cabin of a W124 mercedes is impossible. Current setup: Temp 1999 panasonic HU rockford 300.2 for fronts rockford 200.2 for rears rockford 400.1 for sub Leaning towards a 8" in an exponential horn DAMN YOU GERMANS AND YOUR 5" SPEAKERS!
Autruche Posted June 25, 2011 Report Posted June 25, 2011 Edit: NVM, I see that it's a 5 channel. Need Test Tones/Sine Waves? Click Here!My Saab 9000 build1993 Saab 9000 Aero 5spdPioneer - Zapco - Hifonics - Sundown Audio - O2 Audio - RE AudioJust Say No To Rear SpeakersJust Say No To CCA WireReal Men Drive StickHit me up on Facebook, if you want
homiewes Posted June 25, 2011 Report Posted June 25, 2011 try it and see what happens LOL My youtube channel, please subscribehttp://www.youtube.com/ballinblaza
Watch the bass Posted June 25, 2011 Report Posted June 25, 2011 My link , maby you can read it better in the manual im German, but in my oppinion it will work. "in the abundance of water, the fool is thirsty" Bob Marley
wafsman Posted June 25, 2011 Author Report Posted June 25, 2011 Thanks for the replys, I just didn't want to waste my money if the amp is going to go into protection cause the wrong impedance.
Recommended Posts
Archived
This topic is now archived and is closed to further replies.