quick 45's question

[tonedeaf]

Broken img link. Link doesnt work.

[tonedeaf]

As said though...glue/seal corners and good countersunk screws and you wont have to worry about it. Too worried about the small thing bud.

[zx10intn]

betwen I-K, J-L, A-E and H-D, once again its not necessary and maybe overkill, but if you want to do it go ahead, it wont hurt anything

[stipek]

Oops forgot to erasw the first http...here it is.

Here is a super rough draft of the box. Between which points do you suggest the 45?

[zx10intn]

Oops forgot to erasw the first http...here it is.

Here is a super rough draft of the box. Between which points do you suggest the 45?

i just told you in the post above this one.... but once again, in this build its just because you want them there, theres likely no real benefit

[Supercharged DCs]

I can't read the handwriting too well, but if you are stuck on putting 45s, do it in the pressure poInts, which I believe is A-i (A going diagonally) and D-J (D going diagonally)

[stipek]

Here is the "T" divider using 3" pvc. So it only extends down the port 1 1/2 inches and the port width at the top is 2 1/2 inches. Should I make an extension from that down the port farther or will this be ok?

[BJD3]

If I remember correctly Fecoupe said the flat topped separator is what worked best for his box. Like /T\ but without the leg in the T if you get what I'm saying. Yours may differ though.

Like if you took what you had, spread it out a bit, and put a piece of mdf in the middle. In the same thread, someone else said they lost when they did the same thing, and a separator like what you have worked better. The general consensus was a separator made a difference though.

Moral of the story? Try it and see what works best. Between the three options (none, flat topped, peaked), I think it was like a two or three db difference.

EDIT:I was wrong on a few of the specifics. Read this thread.

http://www.stevemeadedesigns.com/board/topic/114812-middle-port-triangle-poll/

Edited July 19, 2011 by BJD3

[stipek]

Good thread...thanks. I think I will flatten it back out and then put a piece of wood at the end to run it down the port a little farther. I could just redo with the wood inbetween the two Pvc pieces but I'll probably have to 45 the bend because I don't want to choke it too much. Also think I'll do pvc on the two pressure points just because.