1988 Cavalier,widebody build,one piece flip ip front clip...a long drawn out build...

[htx kustoms]

It feels so wrong to give you advice but i would leave them like that so you could get tips that would fit there perfectly square cut outs would have to big of a cut out unless your gonna put mesh then the muffler... Also when you bag it will there be enough room for the exhaust to go all the way back...and sorry for giving my opinion but you asked !!!

[bibby>Chode]

no cut outs bro.

Leave it clean, smooth, and simple. Honeslty, i think the exhaust holes are a bit much, BUT i'm sure you can pull them off once you get the exhaust in the holes.

[Torres]

SO hard of a decision. imo i think a few cuts with a mesh grill would be sexy. would it be too much? i dno...it looks sexy smooth too

hmmm...looking at it some more, IF you did cut it, (i'm not sure how you officially plan on doing the exhaust, whether to slightly poke them out, or keep them behind mesh) i'd cut the ones with the exhaust and put the mesh on them, but maybe leave that middle cut out. or perhaps just change the shape a lil. i dont have photoshop, but ima see what i can do with paint

[Torres]

that's the best i could come up with in paint. best mesh pic i could find online lol. hopefully gives at least a little idea on looks. i think i personally like it better with the 2 bottom being cut rather than all 3

[LSN2meBoom916]

some underside shots

That yellow line......is the extent of the mudd that is in the bumper so far....

Showoff.

and THAT is NUTS! (but I already knew it cuz I been payin attn and I aint seen you sling mud once yet.

Please Continue O.B.1.

these are the chunks I cut off the bottom of the rear corners...

Also showin off....and OMFG dude!

Ready to go "battle-bots" with Davids Tank he's buildin?

On the Q:

I'm with ExpoSport I think....

I like the squarish cutouts and mesh Idea.

I'm not sure about the center cutout..but the 2 for the exhaust is clean as I picture it....

One Q tho-

would the exhaust openings be BEHIND the mesh? or continue all the way to the kit surface and poke out a lil bit?

Also as mentioned....Is that gonna be Kosher with the raising/lowering via the bags?

Lookin pimp tho fershizzle.

[andym85]

yea, i dont think you should cut the middle out....espeically since you kinda 'rolled' the bumper under a tad...i say keep it clean and sexy.

i have no idea what your planning for the exhaust (like everyone else said), but i would just cut the exhaust holes out to where they fit REAL snug around the pipes...pipes being flush to the bumper...and no mesh...

/$.02

[groundpounder2k2]

that's the best i could come up with in paint. best mesh pic i could find online lol. hopefully gives at least a little idea on looks. i think i personally like it better with the 2 bottom being cut rather than all 3

see...........now i like that....

If i left it smooth....and "clean" i think itd be just too much bumper.....

gotta break it up...

[groundpounder2k2]

well unfortanantly ....im out of sandable primer.... http://www.stevemeadedesigns.com/board/public/style_emoticons/default/mad.gif and i dont have the extra funds right now,to go and get some... http://www.stevemeadedesigns.com/board/public/style_emoticons/default/mad.gif

so,where i would Normally be using sandable primer you get to see me use whatever paint is on the shelf

green............whodathunkit

[groundpounder2k2]

[groundpounder2k2]

Yes chris,im slangin mudd