meade916 Posted July 2, 2013 Report Share Posted July 2, 2013 Ok it is Monday night, again, but it is 10pm here, and is Tuesday SOMEWHERE I will upload the results tomorrow.for now, lets see some guesses.I tested it @ 12v (rated) in these modes.8ohm bridged - Rated 25x1 4ohm bridged - Rated 100x12ohm bridged - Rated 200x11ohm bridged - Rated 500x11/2 ohm bridged (1/4 ohm!) - Rated 500x1I also tested it @ 14v 1 ohm bridged - 1/2 ohm bridged - the amp comes with a 40 amp maxi fuse.now there is 3 modes for each test (certified @ 1 % distortion, clipping, and dynamic RMS). This time, guess the MOST power in each catagory i was able to squeeze out of it and add them all up. Only ONE number per ohm load. It says 25x1 in 8 ohms bridged, pencil down the MOST i got (not all three modes combined, just MOST). Then do each impedance the same till the end and add them up. This is a small amp so i am going to raise the margin of error to 20 watts. Anyone who gets within 20 watts of the number i have in my hand, will get an SMD VM-1 or OM-1 (your choice) when it is released. The VM-1 is already out, OM-1 in a few weeks. Remember, one maximum number for 8, one for 4, one for 2, one for 1, one for 1/2....PLUS the 14v numbers too. Then add them up. But i ONLY tested in the impedance shown above.your total number will be MUCH bigger then 500w, because they are all added up. If i had you guys guess the highest actual number, i would have 20 people answering the same answer, so i gotta mix it up and have some fun with it have at it, good luck! 1 All SMD products + MORE available at my store here! https://wccaraudio.com/ Subscribe to My Youtube Channel! Over 1,000,000 subscribers strong! Turn on your notifications! http://www.youtube.com/meade916 Follow My Instagram! Daily live feeds from the shop, exclusive content way before it hits my Youtube channel...and little squares with photo's in them http://www.instagram.com/meade916 The Official SMD Facebook fan Page https://www.facebook.com/SteveMeadeDesigns/ Follow my Tweet (Twitter) http://www.Twitter.com/meade916 Link to comment Share on other sites More sharing options...
meade916 Posted July 2, 2013 Author Report Share Posted July 2, 2013 by the way, 1/2 ohm bridged = 1/4 ohm.....is CRAZY...and the amp is rated to do it. So i guess i had to do it. Most amps, i would NOT. 1 All SMD products + MORE available at my store here! https://wccaraudio.com/ Subscribe to My Youtube Channel! Over 1,000,000 subscribers strong! Turn on your notifications! http://www.youtube.com/meade916 Follow My Instagram! Daily live feeds from the shop, exclusive content way before it hits my Youtube channel...and little squares with photo's in them http://www.instagram.com/meade916 The Official SMD Facebook fan Page https://www.facebook.com/SteveMeadeDesigns/ Follow my Tweet (Twitter) http://www.Twitter.com/meade916 Link to comment Share on other sites More sharing options...
purplesyrup Posted July 2, 2013 Report Share Posted July 2, 2013 My answer, all combined 2,355 Link to comment Share on other sites More sharing options...
Smoove Posted July 2, 2013 Report Share Posted July 2, 2013 1844 2 Team Fi 15's v1 2 DD M5's 970amps of Alt 6th order blowthroughThe truck Blowthrough build : http://www.stevemeadedesigns.com/board/topic/155555-smooves-1996-chevy-ext-cab-c1500-slow-build/The 350z build : http://www.stevemeadedesigns.com/board/topic/170694-smooves-2003-nissan-350z/ My FB page https://www.facebook.com/pages/Smooves-Car-Audio-and-performance/719746144805343 Team Fi Audio http://www.ficaraudio.com/ Link to comment Share on other sites More sharing options...
BoomZoom808 Posted July 2, 2013 Report Share Posted July 2, 2013 2420 2010 Mazda 3s 2.5L Pioneer DEH-X9600BHS Knu OFC 1/0 SS Platinum AGM / XS Power XP750 Alpine PDX F-4 / Morel Maximo 5 + Coax 5 IA 10.1 / SSA XCON 12 Link to comment Share on other sites More sharing options...
Trey Totman Posted July 2, 2013 Report Share Posted July 2, 2013 1956 Link to comment Share on other sites More sharing options...
pa-pa-platypus Posted July 2, 2013 Report Share Posted July 2, 2013 2248 This isn't teeball. YOU DO NOT GET A TROPHY JUST BECAUSE YOU SHOW UP. Put the work in and then maybe get the respect when it has been earned 151.6 with single 12 at 41 hz 153.2 with 2 12's at 43 hz power: dd m4 Link to comment Share on other sites More sharing options...
Steven Bulgin Posted July 2, 2013 Report Share Posted July 2, 2013 (edited) im guessing 1.768 total watts output Edited July 2, 2013 by Steven Bulgin Link to comment Share on other sites More sharing options...
dugjt88 Posted July 2, 2013 Report Share Posted July 2, 2013 1984 They call me Girth "The Silo" Brooks- I ain't storing corn Link to comment Share on other sites More sharing options...
R James Trapp Posted July 2, 2013 Report Share Posted July 2, 2013 1050 Link to comment Share on other sites More sharing options...
Recommended Posts