Need building print for hds212 enclosure. First time builder and site user.

[nativewelder217]

Searching for print enclosure for my single hds212. All the ones I been looking for are 2cubic feet. Which do not account for subwoofer volume. Website says my sub diplacment is .7. I would like to run it at exact volume 2cubic feet with sub. Please help.

[3vil]

Take one of those 2ft³ plans and make .7ft³ larger.

[ShadeTreeMechanic]

Don't forget to subtract port volume from total volume too.

[nativewelder217]

Do you guys know where I can get a build print?

[Triticum Agricolam]

Do you guys know where I can get a build print?

Post your max dimensions, what vehicle its going in, and what amp you are using and I'm sure someone will come up with something for you.

BTW, your sub doesn't displace .7 cubes, probably more like .1 cubes.

[3vil]

Well, a piece of paper and a pencil will work in a pinch, have you tried that? Helps to have a tape measure so you know what room you have to work with. Buy off the top of my head: 33.9w x 13.5h x 12.75d. I think that's approximately 4,666in3, which should be about where you want.

[Joe X]

Do you guys know where I can get a build print?

Post max dims for a box, vehicle and amp models, that sub driver displacement is 0.07 cubic feet.

[nativewelder217]

W×26 Hx17 Dx15 max dimensions. 2012 Ford fusion. Amp rockfordfosgate 1000xbd mono. What type of screws and glue is best to use?

[Joe X]

So here is a suggestion, power: to sub rated, amp subsonic filter to 28Hz, minimum port clearance 2 1/4", figure is just an assembly guide:

NOTE: If building outside you need to build a cardboard dummy box to test fit in it's way inside.

[baller95]

There's not enough space in your max dimensions for two of those subs, anyways you can use MDF screws to complete your project.

I think he's just using one of those subs!