How do i wire to a 1ohm load?

[Alex K]

like i said...

[Kranny]

whats wrong with the diagram thats hddores image and i was just running it to the amp

i was just asking because its hard to tell where the coils are since in your picture the leads are all evenly spaced apart when on a woofer the + and - for one coil are literally right next to each other and the + and - for the other coil are on the opposite side.

[Team_DC-Derrick]

if all you assholes look back and look at who posted the right answer first, you will see its me, so all you are copying what I said !

I win !

[Alex K]

derrick sucks big nuts.

DO THIS OP! ^^^^^^^

[Katt]

tsuch, since your amp is mono, just hook the subs together, like what the other members posted from 12volt, then it will work, and you will use 1 Terminal on the amp, not 2. It's easier to follow what they say.

[byers319]

if all you assholes look back and look at who posted the right answer first, you will see its me, so all you are copying what I said !

I win !

well, i wouldnt celebrate yet, pretty sure hes still confused with his last picure

[tsuch20]

hddore confirmed my picture. that will use both terminals. i bought the wire would like to use it.

[Team_DC-Derrick]

if all you assholes look back and look at who posted the right answer first, you will see its me, so all you are copying what I said !

I win !

well, i wouldnt celebrate yet, pretty sure hes still confused with his last picure

its ok to for the OP to be confused as long as I am not spouting out misinformation then im happy

[AMI CUSTOMS]

Wire each sub together in series for 2 ohm and then go to the amp with the remaining two terminals. You will connect all four terminals of the amp speaker outputs.

[Katt]

Tsuch, just do this :

That should be correct.