wL<3bass

.67ohm

Bump interested in others results...

Steve's thread got me thinking about hearing and what frequencies we can hear at a different age and what not... Steve's thread: my dog Rock gets a 22khz hearing test - funny! So I was just looking around and stumbled onto this hearing response curve test and was interested to see what some other peoples curves looked like compared to mine... LINK TO HEARING RESPONSE CURVE TEST! Instead of their direction, I left my headphone are my normal volume and went up from the bottom until I could clearly hear the frequency, DO NOT ADJUST YOU VOLUME... Just for reference I'm 19 I've been into loud stereos for awhile, shot many guns without hearing protection and what not and think I have pretty good hearing... Anyways take the test and lets see what others response curves look like comparison to mine, take a screen shot of you screen and post up

What kind of enclosure? tuning? driver orientation?

How are they overpriced?

I'm not so sure about that... The new Camaro is definitely something to be reckoned with... LS series motors loves boost even a stock bottom end...

I hope you fully know what you getting into when you decide to swap something, and turbocharging a N/A motor takes a bit of knowledge... If your not an EXPERIENCED in engine rebuilding and engine wiring.... You may want to pay someone to do it...

You'll blow 'em solely because your brool wasn't story enough co

Needs deadener and some bracing... My roof was worse than that, put 3 layers of second skin on it and foamed the roof braces, problem solved.

single 4ohm coil? was this built for HT use?

Yup for sure man, welcome to the forum

Sounds like my fav 4 ch amp T15004, huge, 1ohm stable, and powerful... I may have to get 1 of these

8400

I lol'd seriously!

That's why I haven't eaten anything from mcdonalds in about 6 months... stuff makes me sicker than ever after having my gallbladder out...

Take a look at my box builds might give you a few pointers to painting mdf.

Way to post dump to gain post count...

Haha you're right, I was making food while drawing that... that would be 8ohm... he needs to parallel the coils then to the amp.

I just looked and seen your running 2 600 ID amps, why are you gonna run CVRs off those great amps?

2ohms is the lowest ohm load you can wire each woofer... so each amp will see a 2ohm load and each amp is rated at 400wrms @ 2ohm. The subs are rated at 1-500wrms each, you'll be giving each sub 400wrms...

Yu don't have the jumpers for the other coil so thats wrong... The way that drawing is you would only have one of two coils hooked up and it would be at 4ohm.

Gotta love blazers lol...