all4spl Posted September 7, 2012 Author Report Share Posted September 7, 2012 Where did you run the signal wires after you went through the center consol?i ran mine under the carpet mound between the two rear footwells and then under the back seat I was just curious if there was a better way. Clean install though. It motivated me to clean up my wires more in my 96 accord! Lol Mine goes straight up the center between the two split back seats into the hatch. Retired from SPL again.... 2016 IASCA Truck/Trunk 2 Champion 151.8db 2016 IASCA Truck/Trunk 2 World Record Holder Link to comment Share on other sites More sharing options...
all4spl Posted September 7, 2012 Author Report Share Posted September 7, 2012 Ok, got it wired up with the socket and diode now. Retired from SPL again.... 2016 IASCA Truck/Trunk 2 Champion 151.8db 2016 IASCA Truck/Trunk 2 World Record Holder Link to comment Share on other sites More sharing options...
all4spl Posted September 7, 2012 Author Report Share Posted September 7, 2012 Well I think I did this correctly, this is a diagram I made of how I wired my relay with the diode. Retired from SPL again.... 2016 IASCA Truck/Trunk 2 Champion 151.8db 2016 IASCA Truck/Trunk 2 World Record Holder Link to comment Share on other sites More sharing options...
all4spl Posted September 7, 2012 Author Report Share Posted September 7, 2012 Well I got a lot done, its about 98% I am not too keen on the wiring how it looks but with the space limitations it's about as good as I could do, I may look into making my own buss bars to go between the batteries later on. Here is the amp rack just before putting the batteries in and the enclosure over the amps. Here are the two shots of the batteries, and there you can see the main fuse between the battery up front and the two in the rear. And here is the back of the sub box completed finally carpeted the panel so it looks much nicer now. Retired from SPL again.... 2016 IASCA Truck/Trunk 2 Champion 151.8db 2016 IASCA Truck/Trunk 2 World Record Holder Link to comment Share on other sites More sharing options...
scooter99 Posted September 8, 2012 Report Share Posted September 8, 2012 Where did you get that barrier strip? That's pretty sweet! Would save you a ton of time for soldering wire terminals. Looks like it's wire in and set screw is that correct? Facebook Page: S99Creations 2006 F250 Lariat Build Link to comment Share on other sites More sharing options...
all4spl Posted September 8, 2012 Author Report Share Posted September 8, 2012 There's a place here in orlando called Skycraft surplus, they have a TON of stuff. They do have a website too, http://www.skycraftsurplus.com/ you can email them if you have a question or what not they are very good about helping out when you can't find something on their site. The strip cost $3 btw. Retired from SPL again.... 2016 IASCA Truck/Trunk 2 Champion 151.8db 2016 IASCA Truck/Trunk 2 World Record Holder Link to comment Share on other sites More sharing options...
scooter99 Posted September 9, 2012 Report Share Posted September 9, 2012 Thanks for the link and info. Much appreciated! Facebook Page: S99Creations 2006 F250 Lariat Build Link to comment Share on other sites More sharing options...
all4spl Posted September 11, 2012 Author Report Share Posted September 11, 2012 200amp externally regulated alternator is on order Retired from SPL again.... 2016 IASCA Truck/Trunk 2 Champion 151.8db 2016 IASCA Truck/Trunk 2 World Record Holder Link to comment Share on other sites More sharing options...
Colton Holaway Posted September 11, 2012 Report Share Posted September 11, 2012 Im not one for hondas but iv always liked the new fits somthing about them being so tiny but so much space for subs bumpin on a budget 2 cvr 12's 1800.2 power acoustic bamf sealed box 2.3 cub each net all in the trunk of a 98 grand am gt 4 dr Link to comment Share on other sites More sharing options...
Swordlordboy1234 Posted September 11, 2012 Report Share Posted September 11, 2012 Im not one for hondas but iv always liked the new fits somthing about them being so tiny but so much space for subs I find this offensive sir! My 96 Accord EX is a better car then my gf's 2006 loaded Kia spectra..... Go figure. Looks cleaner, less body damage, more mechanically sound, better paint, more "power" features, more HP, I think mine has more room, deff a bigger trunk. But she does have MPG on me. I get 20/28 she gets 28/34 . But mine will soon have a completed system! Haha! Upper hand is still mine. (but most of that stuff has to do with her inability to take care of her car ) My old YouTube channel : http://www.youtube.com/user/SwordLords1234?feature=mhee My old build log : http://www.stevemeadedesigns.com/board/topic/161872-96-accord-b2-sundown-sky-high-dc-power-re-re-build-for-heatwave/page-37 My New Build - http://www.stevemeadedesigns.com/board/topic/207041-2016-mazda-6-sql-build/ 2016 Mazda 6 Touring JL Fix 86 - OEM signal correction B2 prototype DSP 6to8 B2 Ref63 - 3 way active set 2 B2 Class H quattro's 1 B2 Zero.5R @.5 2 B2 HNv3 12 d2 B2 SLIP40 - Lithium in the trunk Northstar Group 35 under the hood 100ft 2/0 welding cable 30ft 4ga welding cable 20ft 8ga welding cable All stinger OFC speaker wire Soundrive custom RCA's Tons of attention to detail.... Can it be perfect? Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.