Jump to content

Team Envied Kreationz Avy 6 Fi Team 15's & 3 DC 9k's!!!


Recommended Posts

The belt is very tight

I never liked how tight it was either

2008 California state record holder 157.2 Bassrace2009 California state record holder 157.0 BassraceRollin 50's 158.7db2009 King of Cali Bassrace2009 USACi score 160.5 @ 42hz
Link to comment
Share on other sites

Yeah its really tight and Im hoping it releases some of the tension so the tensioner goes back to the normal position or at least close.So Ray when you wire two alternators do you have to have a plug for both or not?Reason I asked is because the harness I got only has one plug on it.

Vehicle
2007 Chevrolet Avalanche(Co-Co)

DNX9980HD
6 Team Fi 15's(King Edition)
3 DC 9k's
8 Nendo PWX 8's
4 Custom Steg 4" Super Tweeters
1 DC Audio 175.4
1 DC Audio 90.4
Rockford 360.3
3 DC Power 370xp Alts(Externally regulated)
21 D1600's
2 D4800's
All SMD RCA's
AudioTechnix Deadner
Viper Alarm

My YouTube- http://www.youtube.c...NG?feature=mhee
Link to buildlog- http://www.stevemead...4-15s-2-dc-9ks/
Link to UBL- http://www.stevemeadedesigns.com/board/topic/165059-ublkings-avalanchecoco-new-build-starting8-king-edition-15-team-fis-in-a-wallyes-a-wall/

96576a0.jpg

Banner3_zpsa237d00a.jpg

Link to comment
Share on other sites

That belt is ultra-tight, my guess is the tensioner will loosen up a tad with 10 minutes of driving, but best to turn it on for the first time with the engine open so you can hear if any strange noises are being made (i.e. if any OEM accessory bearings are being stressed, this could cause a rhythmic "chirping" noise).

I started the truck up and everything sounded good.I let it run for about 10 minutes and today I will take it out and drive it some to see if that belt goes back a little.Here's the picture of the harness and if your saying that it should have 2 plugs then I guess they sent the wrong one.

DSC_00449.jpg

Vehicle
2007 Chevrolet Avalanche(Co-Co)

DNX9980HD
6 Team Fi 15's(King Edition)
3 DC 9k's
8 Nendo PWX 8's
4 Custom Steg 4" Super Tweeters
1 DC Audio 175.4
1 DC Audio 90.4
Rockford 360.3
3 DC Power 370xp Alts(Externally regulated)
21 D1600's
2 D4800's
All SMD RCA's
AudioTechnix Deadner
Viper Alarm

My YouTube- http://www.youtube.c...NG?feature=mhee
Link to buildlog- http://www.stevemead...4-15s-2-dc-9ks/
Link to UBL- http://www.stevemeadedesigns.com/board/topic/165059-ublkings-avalanchecoco-new-build-starting8-king-edition-15-team-fis-in-a-wallyes-a-wall/

96576a0.jpg

Banner3_zpsa237d00a.jpg

Link to comment
Share on other sites

Going to get in touch with DC and have them send me the right harness.I have time since I'm just now measuring out all the wire runs.I can get all the wires ran and ready so that when I get the new harness I can just connect everything.3 of my batteries should be here this week also.I'm not in a hurry as you can tell.I work on this build when I can.Just lately I been able to hit it at least for an hour everyday because I'm off work until next week.Thanks for the help Merz

Vehicle
2007 Chevrolet Avalanche(Co-Co)

DNX9980HD
6 Team Fi 15's(King Edition)
3 DC 9k's
8 Nendo PWX 8's
4 Custom Steg 4" Super Tweeters
1 DC Audio 175.4
1 DC Audio 90.4
Rockford 360.3
3 DC Power 370xp Alts(Externally regulated)
21 D1600's
2 D4800's
All SMD RCA's
AudioTechnix Deadner
Viper Alarm

My YouTube- http://www.youtube.c...NG?feature=mhee
Link to buildlog- http://www.stevemead...4-15s-2-dc-9ks/
Link to UBL- http://www.stevemeadedesigns.com/board/topic/165059-ublkings-avalanchecoco-new-build-starting8-king-edition-15-team-fis-in-a-wallyes-a-wall/

96576a0.jpg

Banner3_zpsa237d00a.jpg

Link to comment
Share on other sites

So a little update.Today I cut the wood for the amp rack and the second rear wall of the box for extra support.Also I still haven't been able to get in touch with anyone from DCPower. Waiting on replies back to my emails and from Kyle here on the forum.On another note I did measure the power and ground wire from the front battery to the rear.Doing 1 positive and 1 negative run from each alternator to the front battery.Then 2 runs of positive from the front battery to the back battery bank and 1 negative run.This should be enough runs seeing how 1/0 is rated at 350amps and 3500watts.Anybody think otherwise please say something.

Edit: Just got an email from Stan new harness should be going out in the morning.

Vehicle
2007 Chevrolet Avalanche(Co-Co)

DNX9980HD
6 Team Fi 15's(King Edition)
3 DC 9k's
8 Nendo PWX 8's
4 Custom Steg 4" Super Tweeters
1 DC Audio 175.4
1 DC Audio 90.4
Rockford 360.3
3 DC Power 370xp Alts(Externally regulated)
21 D1600's
2 D4800's
All SMD RCA's
AudioTechnix Deadner
Viper Alarm

My YouTube- http://www.youtube.c...NG?feature=mhee
Link to buildlog- http://www.stevemead...4-15s-2-dc-9ks/
Link to UBL- http://www.stevemeadedesigns.com/board/topic/165059-ublkings-avalanchecoco-new-build-starting8-king-edition-15-team-fis-in-a-wallyes-a-wall/

96576a0.jpg

Banner3_zpsa237d00a.jpg

Link to comment
Share on other sites

All have been soldered and crimped and then covered and taped.

DSC_00457.jpg

DSC_00467.jpg

Vehicle
2007 Chevrolet Avalanche(Co-Co)

DNX9980HD
6 Team Fi 15's(King Edition)
3 DC 9k's
8 Nendo PWX 8's
4 Custom Steg 4" Super Tweeters
1 DC Audio 175.4
1 DC Audio 90.4
Rockford 360.3
3 DC Power 370xp Alts(Externally regulated)
21 D1600's
2 D4800's
All SMD RCA's
AudioTechnix Deadner
Viper Alarm

My YouTube- http://www.youtube.c...NG?feature=mhee
Link to buildlog- http://www.stevemead...4-15s-2-dc-9ks/
Link to UBL- http://www.stevemeadedesigns.com/board/topic/165059-ublkings-avalanchecoco-new-build-starting8-king-edition-15-team-fis-in-a-wallyes-a-wall/

96576a0.jpg

Banner3_zpsa237d00a.jpg

Link to comment
Share on other sites

Not enough wire bud. I have 3 positive and 2 negative runs. I drop a full volt from front battery to my 4500 wired at .5 ohm. And as I believe you know. that's with dual 270 alts, 1 d3100, 1 d2700 under the hood and 3 d3100's in the back.

Hot Damn you killing me LoL!!! Well guess I better be making some more runs then.

Vehicle
2007 Chevrolet Avalanche(Co-Co)

DNX9980HD
6 Team Fi 15's(King Edition)
3 DC 9k's
8 Nendo PWX 8's
4 Custom Steg 4" Super Tweeters
1 DC Audio 175.4
1 DC Audio 90.4
Rockford 360.3
3 DC Power 370xp Alts(Externally regulated)
21 D1600's
2 D4800's
All SMD RCA's
AudioTechnix Deadner
Viper Alarm

My YouTube- http://www.youtube.c...NG?feature=mhee
Link to buildlog- http://www.stevemead...4-15s-2-dc-9ks/
Link to UBL- http://www.stevemeadedesigns.com/board/topic/165059-ublkings-avalanchecoco-new-build-starting8-king-edition-15-team-fis-in-a-wallyes-a-wall/

96576a0.jpg

Banner3_zpsa237d00a.jpg

Link to comment
Share on other sites

I am tuned in to this build as well :popcorn:. I have been having issues figuring out what ride I wanted next and you are making it easy for me to choose. Its tough for a tall guy 6"8 to find a full sized ride while making sure your family have enough room (and of course some sounds). I still have a few months before I'm gonna make any moves to buy so I'm sure I'll get some great ideas from your build. I'm sure you hear this, but I make a habit to say this to every soldier I have ever met. Thanks for what you do for our country! Its the people such as your self that serve our country and make it safe for us to live here. :clapping:

2006 Chevy Trailblazer ~ KX 1200.1 ~ 2 Skar VVX 15" ~Big 3 upgrade ~ Pioneer AVH 4100 ~ 275 Amp Singer Alt ~ PRV 6.5 front doors~ 6000K Hids

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

  • Recently Browsing   0 members

    • No registered users viewing this page.
  • Who's Online   0 Members, 0 Anonymous, 1427 Guests (See full list)

    • There are no registered users currently online
×
×
  • Create New...