RickyFriery97 Posted January 15, 2012 Report Posted January 15, 2012 I have one DC XL 18" powered by my RF T2500BDCP, it's been playing for a few months and is fully broken in I will have a freshly reconed XL 18" with the next few weeks, I will be running the pair on the RF T2500bdcp @ 1 ohm, will I have any problems with one being new and one fully broken in? Quote 2014 Chevy Silverado Crewcab 1994 Chevy Full Size blazer
battlewalrus Posted January 15, 2012 Report Posted January 15, 2012 (edited) Just run them both at lower volume until the other is broken in Edited January 15, 2012 by battlewalrus Quote 2005 Honda CR-V AQ HDC315-A Hifonics BRZ1700.1D .5 Ohm 4.4 ft^3 box Kenwood Deck Big 3 XS Power D5100R Starter, D975 Rear
gowerryan Posted January 16, 2012 Report Posted January 16, 2012 what i ve heard about sub break in is that f it let emm bump but idk never rlly put it to the test Quote 95 toyota corolla 1.8 dohc 5 speed system in planing stages right now
bre2ts Posted January 16, 2012 Report Posted January 16, 2012 you could play the fresh reconed one free air at a low freq, low volume for a little to lossen up the suspension Quote Feedback 1 | Feedback 2 you win some, you lose some
TeamHT Posted January 16, 2012 Report Posted January 16, 2012 what i ve heard about sub break in is that f it let emm bump but idk never rlly put it to the test If you read the post correctly, that is not the case. you could play the fresh reconed one free air at a low freq, low volume for a little to lossen up the suspension This is what I would reccomend. Or bump the new 18 in the same enclosure and rebuild once both have been broken in. Quote Tell me...does this smell like chloroform to you?
alaskanzx5 Posted January 16, 2012 Report Posted January 16, 2012 just dont go full tilt for a lil bit Quote t1500bdcp 2 t2d4 15" 1 t600.4 1 t400.2 1 set p1 tweets singer alt, tons of wiring, smd vm-1, 80prs, back seat delete, still in the works, aiming for a 145-147 with the ability to play 25hz up to 50hz.
RickyFriery97 Posted January 16, 2012 Author Report Posted January 16, 2012 what i ve heard about sub break in is that f it let emm bump but idk never rlly put it to the test If you read the post correctly, that is not the case. you could play the fresh reconed one free air at a low freq, low volume for a little to lossen up the suspension This is what I would reccomend. Or bump the new 18 in the same enclosure and rebuild once both have been broken in. I didn't think about running the new one in my current enclosure, I may just do that Good idea! Quote 2014 Chevy Silverado Crewcab 1994 Chevy Full Size blazer
TeamHT Posted January 16, 2012 Report Posted January 16, 2012 Quote Tell me...does this smell like chloroform to you?
AA98hoe Posted January 16, 2012 Report Posted January 16, 2012 (edited) Id run the new one alone for a while... I tried the freeair trick and it takes time and doesn't work that great I think running it on music in the box is best...oh and id do 10 cubes net with 160sq of port tuned to 36... for 2 subs should slam... I've tried bigger in my hoe and didn't like it. I got those specs from a buddy that had 2 slamming in his hoe... Edited January 16, 2012 by dc98hoe Quote TEAM DC AUDIO VEHICLE:98 chevy tahoe 2wd 3-4 drop HEADUNIT:alpine 9886 PREAMP:arcaudio FRONT STAGE:4-6 1/2s selinium,DD component set and 4-selinium tweeters in each door KICKPANELS:jl audio 5 1/4 REAR DOORS: dd components 6 1/2s HIGHS AMPS:zapco 750.2 on front doors,zapco an another 750.2 on kicks and rear doors SUBS:4-ascendant audio 18s with 5 spiders in a custom box built by KINGSUV SUB AMP: 2-dc7.5s ALTERNATORS: 3-mechmans 1- 425comp, 1-smd spec350, 1-270 with adj voltage harness on custom dc bracket WIRE:10-runs 0g front to back BATTERIES:6-d1400s TL results:157.1 at 38hz and 156.8 at headrest score @37hz. STATE AND NATIONAL RECORD IN MECA S5.
RickyFriery97 Posted January 16, 2012 Author Report Posted January 16, 2012 Id run the new one alone for a while... I tried the freeair trick and it takes time and doesn't work that great I think running it on music in the box is best...oh and id do 10 cubes net with 160sq of port tuned to 36... for 2 subs should slam... I've tried bigger in my hoe and didn't like it. I got those specs from a buddy that had 2 slamming in his hoe... yea i will probably throw it in my current enclosure til its broken in and take my time building a nice new enclosure i kinda feel like 10 cubes net is a lil small for 2500wRms for the pair, im thinking start with 12 cubes net and maybe make some removable parts to shrink the box and see what works better. im not interested in numbers this is a daily GP but i hope for atleast a 50 out of it Quote 2014 Chevy Silverado Crewcab 1994 Chevy Full Size blazer
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.