dog24fret Posted July 26, 2012 Report Share Posted July 26, 2012 Where do you get these at? Quote Cowboy Escort GrAnny ThUmper The Burp Link to comment Share on other sites More sharing options...
Sonic Posted July 26, 2012 Report Share Posted July 26, 2012 (edited) Where do you get these at? http://www.sonicelec...t%5BIgnore%5D=1 P.S. I have no Affiliation to that company. just sayin , you can find it else where as well... Edited July 26, 2012 by Sonic Quote Link to comment Share on other sites More sharing options...
dog24fret Posted July 26, 2012 Report Share Posted July 26, 2012 Thank you sir. Can one handle two mono amps. I hope this isn't post jumping. Quote Cowboy Escort GrAnny ThUmper The Burp Link to comment Share on other sites More sharing options...
HunterJohnson Posted July 26, 2012 Report Share Posted July 26, 2012 yeah you're fine wire as many as you want. Quote Scion tC SQ BuildiPad mini, lots of fabrication, daily drivenFord Explorer C Pillar Wall Build Just a cheap car to destroy with bass Link to comment Share on other sites More sharing options...
ChevyBoy95 Posted July 26, 2012 Report Share Posted July 26, 2012 LC-1 = Quote Best Score to Date : 160.5 dB Outlaw (47Hz)[4 XM 15's & 2 Taramps Bass 12k's] BL : http://www.stevemeadedesigns.com/board/topic/147800-chevyboy95s-4-15s-7krms-wall-1533-db-on-half-power/YouTube: http://www.youtube.com/hitemwiththeflex/ Link to comment Share on other sites More sharing options...
dog24fret Posted July 26, 2012 Report Share Posted July 26, 2012 Thanks. Quote Cowboy Escort GrAnny ThUmper The Burp Link to comment Share on other sites More sharing options...
SojiaRaggs9000 Posted July 26, 2012 Report Share Posted July 26, 2012 (edited) LC-1 is pretty decent but what I prefer is the Audio Control LC2i (9.5 volt pre outputs) you can add a knob to this unit as well. Its mostly for factory setups. http://www.sonicelec...ntrol-LC2i.html this one is Great too but no knob.. But you can use it with after market HU's RF BLD (line driver 11 vrms or 22 vrms mode) Works off high level inputs and low level inputs and gives you low level outputs. http://www.sonicelec...ate-RF-BLD.html Edited July 26, 2012 by SojiaRaggs9000 Quote * Eclipse CD3200 with PAC SWI-CAN2 and SW-ECL2 Steering Wheel Controls Interface* Pioneer D-Series Mids and Highs ( Fronts: TS-D1702C; Rears; TS-D1702R and Dash; TS-D1002R )* Rockford Fosgate PBR300X4 ( Mids and Highs Amp )* DC 3.5k with Dual Inputs; Custom Plexiglass Backing ( Sub Amp )* Rockford Fosgate Balanced Line Driver * One FULLY LOADED ~ 10" DC m2 XL* Custom Built Carpeted Ported Box Tuned to 32hz. Single Chamber With Volume of 1.44618³ ft ; 1.13216³ ft After Displacement* Custom Built Carpeted Trunk Wall with Added Fans for Amplifier Cooling* MechMan 240a High Output Alternator * KnuKonceptz Krystal Kable RCA Cables* Upgraded Electrical With 1/0 KnuKonceptz Kolossus Fleks Kable and 1/0 Sky High Car Audio Cable* Five Exide Orbital ORB34M Marine 12 Volt Batteries* PowerMaster XS D3100 12 Volt Battery My 2008 Chrysler 300 Limited - SuperCharged 3.5L V6 - UBL My Old 2005 Ford Taurus - CarDomain - Vehicle Was Sold Link to comment Share on other sites More sharing options...
CJ18 Posted July 26, 2012 Report Share Posted July 26, 2012 PAC lc1 I use the DC bass Knob it works ok, a little surprised CJ18 said LC-1 and nothing about the DC one I hate stock bass knobs. I prefer the lc1 because it gives me full control over the signal going to the amp. If I want no bass i just turn the knob all the way down. Quote Link to comment Share on other sites More sharing options...
tdsa23 Posted July 26, 2012 Report Share Posted July 26, 2012 PAC lc1 I use the DC bass Knob it works ok, a little surprised CJ18 said LC-1 and nothing about the DC one I hate stock bass knobs. I prefer the lc1 because it gives me full control over the signal going to the amp. If I want no bass i just turn the knob all the way down. That is very true might have to make a switch. Quote XS Power D5100, 2 D2700s, & 2 D975s MechMan 220a Alt DC 5K Kicker 650.4 2 12 Ascendant Audio Mayhem's Pioneer DEH-P7200HD Rockford Fosgate 3sity.1 Build log: https://www.stevemeadedesigns.com/board/topic/166792-88-nissan-maxima-trunk-build/#entry2430899 https://www.stevemeadedesigns.com/board/topic/191439-lexus-is300-fi-crescendo-shca-rf-pics/ Link to comment Share on other sites More sharing options...
viper1315 Posted July 26, 2012 Author Report Share Posted July 26, 2012 thank you everyone looks like i need to get one Quote 2001 GMC Sierra DC Audio Build =http://www.stevemead...o-level-4-build 2001 GMC Sierra XSPower D3400 Pioneer AVHD 1400 MB Quart Component Sets Pioneer 5x4s Audiotechnix Power Wire, Speaker Wire, Sound Deadener DC Audio Level 4 10s DC Audio 3.5k Rocford Fosgate R400-4 HID 6k Slammed Truck on 20s Candy Blue. Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.