Jump to content

what do you loath having to do during an install


Recommended Posts

Running wires is the worst thing .. Especially when rushed at work an I hate doing custom trim panels in trunks that have to follow contours of wheel wells etc .. Very time consuming ..oh a carpeting panels can't stand spray glue on my hands lol

TEAM DC AUDIO

VEHICLE:98 chevy tahoe 2wd 3-4 drop

HEADUNIT:alpine 9886

PREAMP:arcaudio

FRONT STAGE:4-6 1/2s selinium,DD component set and 4-selinium tweeters in each door

KICKPANELS:jl audio 5 1/4

REAR DOORS: dd components 6 1/2s

HIGHS AMPS:zapco 750.2 on front doors,zapco an another 750.2 on kicks and rear doors

SUBS:4-ascendant audio 18s with 5 spiders in a custom box built by KINGSUV

SUB AMP: 2-dc7.5s

ALTERNATORS: 3-mechmans 1- 425comp, 1-smd spec350, 1-270 with adj voltage harness on custom dc bracket

WIRE:10-runs 0g front to back

BATTERIES:6-d1400s

TL results:157.1 at 38hz and 156.8 at headrest score @37hz. STATE AND NATIONAL RECORD IN MECA S5.

Link to comment
Share on other sites

  • 3 weeks later...

Doing an install on a 25 year old car that has every single part discontinued, so i have to make every damn thing from scratch. Screw this shit, i'm tired lol.

Link to comment
Share on other sites

Link to comment
Share on other sites

crimping those skimpy little ring terminals on zero gauge. Gosh I dont even like talking about it lol i end up smashing all of them as hard as I can on the garage floor with a hammer

That's the wrong way to do it
Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

  • Recently Browsing   0 members

    • No registered users viewing this page.
  • Who's Online   1 Member, 0 Anonymous, 376 Guests (See full list)

×
×
  • Create New...