Can I Do Subs Up Port Up And Still Knock?

[may03LT]

Ive been trying to come up with a way to fit a 15 cube enclosure in my non-ext trailblazer to go subs up/ port back. No matter what I try there just wont be enough room between the back of the enclosure and the liftgate........so can I go subs up port up and still knock?

[audiofanaticz]

It may, it may not. It all depends how your ports and subs will load. If you cant get them to load properly you will not get the output you wanted.

[Slinky]

if you can fit it sure. but whatever you do dont try and squeeze a 15 in there with too small of an enclosure. just step down to a 12 if you have to

[bumassjeff]

Wall it!!!

[SPL2K]

15 cubes? how many 18's you trying to do in there? 3 or 4?

[Slinky]

woops my bad. i read the post wrong

[Derrick824]

Subs up and ports up will still knock but won't hit as good of #s on the TL. If you don't care about #s then I say go for it. If you do care what it hits then I'd choose something smaller.

[Dale]

I had a sub-up-port-up setup and it sounded cleaner because there was less over-all rattle in my tail-gate. But, I will not bull shit you into thinking that it is louder than sub-up-port back.

The most important thing is how much room the air has AFTER it leaves the port. That is important. If having your port back is too tight of a fit, then maybe it's best to fire it up like I did.

[SPL2K]

Make the box smaller to allow for rear fire port. You dont need 15 cubes.

[BigPimpin91]

Make the box smaller to allow for rear fire port. You dont need 15 cubes.

+1 For Mr.Hughes