Quad SA-8 v.2 Amp help - Box deisgn?

[caskinsro]

Well, I currently have 4 sa-8's, all are d4.

Moneys not exactly all the best right now, so I am trying to find a solution without busting the wallet too hard. (3-350)

But right now I have a Hifonics BRZ1200 powering 2 of them at 1 ohm. The issue is going to be adding 2 more. Really didnt think it through very well, confused D2-s and D4s, figured on wiring (4) d4s to 1 ohm ( I know...)

So with that amp, would it be possible to pick up another one and just run a new set of rca's and remote to power the other 2 all in one enclosure? I know the amp's cant be linked together, but I should be able to use the RCA out to the other amp correct?

Sorry for being quite the newb at everything. Not something I do everyday. Prefer engines

[Joe X]

The BRZ1200 has an output to feed a second amp so you can do that. You will need to gain match though.

[Guest]

cant you strap brz's? that would be the ideal setup for 4 d4's. 2 1200's strapped at 2 ohms (each amp seeing 1 ohm).

[john253a]

T-line on amp you have

[N9neMillahhh]

You need the MLX100 to link any of the BRZs except the 2400, that one can be linked without the MLX100, I looked into this for two HDC310s or a pair of Zv410s with two BRX2000s but they said the 2400 models are the only ones that don't need the MLX100 to strap/link em. I'm not sure where to even find the MLX100.

[N9neMillahhh]

T-line on amp you have

That could be great, but a T-Line for (4) SA-8s would be pretty big right? I know you can make em small but for four of em?

[AI James]

i like 3 cubes, 35hz tuning, 15sq per of port area. was pretty linear.

[N9neMillahhh]

That would work pretty well, I like lower tuning but I'm sure that'd still be a good ass box. I will have my Zv410 in a 1.5cuft @ 32 Hz with about 16sq per of port and 2000w. It's an L-Port but it's gonna be retarded loud. But that sounds like a good base to start off with for a T-Line design. I'd go with that as a starter then fine tune it to your wants.