all4spl

Soooo many youngin's in this thread. I did get to own one of these just not this model, this was the beast I wanted. Purple Passion Linear Power 8002SW. I had to settle for a Purple Passion 2202IQ. This beauty I have never owned but dreamed about everytime I saw it, Phoenix Gold Route 66.

I've installed a couple Audiopipe amps for subs, the standard size 1500 and 1000watt models, both are still cranking in both vehicles fine. The 1500 can be had for $147 on ebay, for the price it's not a bad starter amp.

Ok so I am again no expert, however an old friend of mine Will Alfonso suggested a BP design and below is what I came up with. Specs provided where 5.7cuft 1:1 50sqin of port area 8" long. After the suggested BP design I "tried" to mock one up in sketch up. I prolly got this all wrong but here is a picture of it with some area's left out to view the measurements. I shortened the port based on 1 shared wall, the way I got the length of the port of 5.25" is that I calculated the box like a standard ported box with torres calc at 50sqin 8" long, got the resulted tuning, then changed it to 1 shared wall, accounting for the difference of 4.5Hz I then adjusted the port lower in length till the same (within .01) tuning was obtained. I hope that made sense. Anyway here is the diagram/photo any input would be helpful as this is my first attempt at doing a BP design and I just kinda winged it based on the data given to me of 1:1 with 50sqin of port area 8" long. The box is 1:1 2.9cuft sealed, 2.9cuft ported 50sqin of port area shortened the port length as detailed above. Input? No flames por favor.

Sorry not looking for any trades atm.

shipped to 47303? want to sell the box? PM'd

Going up!

Just need cash, personal reason's id rather not go into gross details.

PM'd

1. Product: Sundown SA 12's Dual 4ohm 2. Specs: Re: 7.07 ohms Fs: 33.96 Hz VAS: 24.63 L Qes: 0.55 Qms: 5.15 Qts: 0.49 Le: 4.84 mH BL: 25.67 NA Mms: 237 g Cms: 92.27 uM/N Sens: 84.22 dB 1w/1m 3. Description/Condition: Used however these have been babied since purchased, they are in mint shape and only see heavy play for a few mins at a time as I do not travel that far to school etc. 4. Price: : $300 for the pair LOCALLY, other than local shipping would be actual cost roughly $25 per sub via UPS ground. 5. Pictures: First two contain the required info in the photo then the rest do not, I am also linking a couple that are HIGH resolution. http://www.bortzmedi...4sale/left2.jpg http://www.bortzmedi...sale/right2.jpg

Not a bad start at diagraming, however I can see you have work to do on improving, especially in your lines. Here is a picture of a diagram I did years and years ago for an IASCA world champion vehicle. This is a pretty HIGH res version of the image so I am just gonna post the link rather than try to squeeze it in this thread. http://www.bortzmedia.com/justindiagram3.jpg

Currently have one of these under the hood, want at least 1 maybe 2 for the back if you have these post pics and price, my zip is 32825 for ref on shipping.

Give me a badass price on all three picked up, and I will take em. I can even pick up from MaliNoob I mean Boom's work since its near my school.

Looks great, and your choice to stay all in a mono-tone style suits you very well.

The colors man wow someone pass me the .... oh wait lol! Looks good, and if you like/love it that is what really matters, tattooing and body art is all about self expression!

Oh his price I stated here was MUCH better than the first one I got from him, which I think was due to the dbags he worked for previously. His tip was totally on me, I didn't even have to tip him but he's a great guy and did a fantastic job with me, especially since this was my first tattoo of this size, my other two are smaller around 3-4"x3-4" where as this one is pretty big.

So I had a tattoo that was about 8 years old, not really digging it anymore so I had an idea of what I wanted and when I got the first estimate I had to wait, was too pricey, however my artist then changed studios and the price got MUCH better, so I just got it done yesterday. Here are the photos of the design, original tattoo, outline then full color. BTW this is my 4th (technically) tattoo but I only show 3 since this was a coverup, also the acutal tattoo was a little different as my artist took out a few small things when I told him I wanted to continue this around my leg later. Design Original Outline Color shots Overall I am very very pleased, and I will be going back in 6 weeks for a minor white/highlight touchup session. Total cost was $300, minus his tip which was $100. And I plan on doing the other half of my leg by the end of the year.

430IX for $115 shipped with insurance has brand new speaker plugs and fully bench tested, does not have a crossover chip.

I have a pioneer GM-7300M in new condition has the manual, hi/low harness just no box. If I recall correctly its 360watts at 2ohm mono rated. Looking for $85 shipped.

9887 is sold, the others are still for sale!

Phoenix gold amp is sold, rest is still up for grabs!

Going up folks!

I have this sitting with two broken tinsel leads, PM me if you are interested.

Pretty firm on the PG price, this amp is solid and very clean power. Also I only ship via USPS Priority mail with insurance so you can count about $15 of that price is shipping and insurance. I ship the same or next day after payment is received, have DIYMA refs as well as I have been on ebay for 14 years.

First up we have an Alpine CDA-9887 very well taken care of unit, if you don't know how good it is well you can read the factory specs here; http://www.alpine-us.../view/cda-9887/ This unit just came out of my own car on May 5th and works beautifully! This unit comes with the mounting cage, trim ring, new iPod cable, wire harness and remote. Asking $250 shipped WITH insurance. Next up we have a Phoenix Gold ZX400Ti amplifier, rated at 100x2 @4ohms and 200x2 @2ohms, with 400x1 @4ohm mono. These amps are just plain goodness, this one has a small amount of rust on the top edge as you will see in the photo, but this has no effect on the amps performance. This amp was fully bench tested and worked very well. Unfortunately PG's website does not have any information on their older amplifiers the ratings I have supplied here were from researching other amps of the same model online. Asking $135 shipped with insurance. Next we have a Panasonic CQ-DFX301U CD player, this unit is in pretty decent shape bench tested fine including the internal amplifier and all pre-outs. Great for a work truck or putitng in a car your selling or whatever its CHEAP! Asking $35 shipped. Next is a Kenwood KDC-X811, this unit is NOT working properly, my bench test showed the following; the faceplate flips just fine both directions, however that was the only function I could get out of this unit. This unit could be used for parts or repaired if you are that good with electronics. Here is some info I found on this unit; http://www.crutchfie...n-KDC-X811.html Asking $35 shipped. And finally we have an oldy but goody MTX Blue Thunder PRO275, this amp is NOT working properly. When connected to my bench it will power up but puts out a distored signal only over the RCAs. Again just like PG there is no info I could find on the MTX site on this amp, however here is what is listed on the bottom sticker of the amp which is intact fully; N-Channel VFET Amplifier, 37.5watts x2 @4ohms stereo, 75watts x2 @2ohm stereo, and 150watts x1 @4ohm mono, 280watts @4ohm mono at 14.4V. Serial # 477GB0499 and MADE IN THE USA! Asking $45 shipped. Well that's it for my first Classified on this site ever, PM or respond here for these items. Thanks

Might have an order for you for a friend, should be able to arrange pick up since we are so close to each other.