SPL KID

2k to 27616?

Back it down a little for piece of mind. From what your expressing your gains are way higher then when you started or would have ever gone. So you can thumb it down a little.

you bring it back to the shop... Best way to fix it.. and free.

one knob goes to the master amp which controls the both of them.

wasn't a dumb question. Not asking it woulda been.

This item is going to need to go to 20 volts minimum for the hardcore!!

I Just got a pair thru madisound the 4 ohm versions.. VERY nice sounding mid range! And it has some really nice lows free air (doors). I would reccomend Madisounds 4 ohm unless you plan to run multiple and just need 8's to work out impedence.

Please somebody PM me the link to this program.... ^^^^ thx EDIT : I found it guys!

To get the most out of it you could do 4 to the top and 4 to the rear and ports to the drivers side. Or something more interestinfg like ports thru the rear deck and 2 on each side of the box and 4 to the rear. Should be nasty either way you go.

he has a sale going on right now.... got to the pin up in the dd-1 forum section

Just buy new better piece of mind that way and your supporting the site.

I'm really thinking about buying one and charging or accepiting gracious donation for doin tunes.. LOL what would be a good price you guys think for a tune since these are basically one use on a personal level.

Type R's all day. Make sure you get the newest model they have available now. Grab the d4 model will wire to 1 ohm and the rise will take you to 2 or so then you will make rated power. You can buy a prefab as long as it meets air specs for the sub requirement. The port tuning is up to you but most prefabs are 35 hertz tune. Just double check before you buy one.

Partsexpress is running a coupe sales right now on speakers as low as $20 a pair plus shipping like $33 a set look below in the bargins section there's links IIRC. The speakers they sell are mostly @8 ohm. I bought some 4 ohm models from Madisound.com So check PE first then compare at Madisound for 4 ohm models. I bought 6 inchers Aurasound NS6-255-4A 6" Paper Cone Woofer 4 ohm Alsoyou can get a adapter templete or just make your own! Most Car audio shops should have some lying around the can give or sell you.

Sub up port to the rear?

Couple things to check.... your low pass crossover setting on the new amplifier turn it up to it's maximum number they come shipped all the way down. Secondly the starting ohm load and the finally ohm load after impedence rise. Playing the sub outside of a enclosure has a huge effect on rise and can put you out of rated power range. But first check the new amp setting get some clamp measurements if possible cause that will tell you alot ( atleast your starting ohm load via a multimeter).

Hey billy101 you have a DD1?

From what i'm looking at you have circular openings in the rear deck into the cabin. Depending on the angle of your rear window you should be able to load of that window to the front dash. What i'm saying you could do is build a box long ways for 2 10 facing thru that deck ported perhaps. It would have to start over the shock towers and bellow that box you could make your amp/extra battery enclosure. Should leave you a fair amount of trunk space and help your score out some. Take a couple measurements of that pictured area between the shock towers and above them. Since everyone thinks you have a gas tank there could become a lethal stealth design...

If you followed the directions your golden. Your also using a SoundStream amplifier which is known for a good cean signal output!

X2 is there a DD-1 or CC-1 in the area.. let us know!

will youTake $300 shipped?

Go with Alpine for good sound quality. But if your going to be doing cosmetic as well as good sound pick out your Sub amps first and then do research on the companies mid/high amps. Best way to base your decision.

3 10's in the trunk on 2 Stetsom 2k6's = 152.4 4 dr Grand Am. Db Drag metering position with no sound deadning.

nope