detroitdb

Great stuff!!! expansion foam, everyonrs favorite remedy...

these amps are confusing though....

so, ill run 1 coil to each channel....@2 ohms so 1500 each coil....

im with you..doing a full do-over next season...its what im workin with for now....but i do have strong electrical...i did hear of people doing a mod of some type...

anybody......please...thanks

Hey guys long time no speak, I know the ap30001d is 2 ohm stable, but ive heard they can run @ 1ohm safely with good electrical. Does anybody have any experience or know this to be true....running a dual 2ohm pap wmd2k 18 to it.. thanks again.

BUMP

Running a sony double-din no navi unit.cant think of the mod # but from 08,good unit low voltage on pre outs only setback.

wow i thought someone would like this...

Unbelieveable!!!! Ive been running 3 amps without using a relay. I never thought it was needed...WRONG... Ive had this annoying buzzing engine whine noise.ive installed several systems and usually the noise comes from a bad ground rca's etc.. I checked everything, looked to smd for any ideas...I came across the thread about relays and i started to think??? remote turn on wire does just that it triggers the relay on each amp individually...so if theres not enough current after turning on the first 2 amps it will give it a partial on hence creating this annoying sound....So at my witts end i took a piece of hook up wire one end to the positive post on my batt and hooked directly to the whinning amp and presto!!! buzzing gone.....So i ran out and bought a 40 amp relay with a 5-gang dist.block and not only the noise stopped, i am getting a much cleaner output across the board.......so anyways i thought i would post this if it helps anybody....

Y SPLITTERS...BEST OPTION...

looking for a motor and basket 18" pierce audio product wmd2k dual 2..circa 2006-2011.....cash in hand...pm me...thanks

OK, guys im gonna finally build this box, does everyone agree i can add 2db by doing this?

im doin small hairtricks with 2 18's out of an h3 @3K

this ones an oldie but a clean install...old school jl.....

lokking good Will!!! i always love a good bail-out!!!

ok, in a bit..or check my youtube page hummer415s...

wait a minute, i think you should make it a little taller...jk..lol...thats gonna be stuuupiddd loud!!!!! looks good

reason im asking, i might be doing a 4 18 inch set-up..gonna add two..or sell these and buy four of something else....

it def. can work, a little elbow grease and a jigsaw...jk...actually its the truth..just take your time and a lil fabrication it will look good....

i have a set of these....dual 2ohm 1.5k rms.....I just want to hear what everyone else thinks of em?

yes, it could be your switch in the drivers door, maybe not. but all the wires go there as well...

lookin good steve!!

sucks baddddd!!!!!

thread bracing wont hurt..40" is a long way....