Socky Posted December 22, 2012 Report Share Posted December 22, 2012 Just to say, ive ran 2 lvl 3 m2's with lvl 4 coils on 2 apsm 1500s wired at 2 ohms strapped, and its fine for the lvl 3's daily. Id push more for burps thats about it. Jeep Cherokee 4dr -4.75 in front, new rusty's 4.5 in rear leafs -micky thompson 35x14.50x15 -locker rear -Rusty's offroad Engine/transmission/transfer case/crossmember/gas tank skid plates -Warn front bumper with 8000lb winch -Custom rear bumper -Warrior product tube doors (summertime) -Optima redtop (starter) -26XK miles and still runs like a bat out of hell Kenwood H/U 1/0 wire, 136 amp alt 200 ah batteries 12.7 daily 2 Apsm 1500 @ 2 ohm strapped on zv3 d1 with ns softparts Mb quart 125.4 wired to 4 aura 6's 3.6 cube box tuned to 36 plays down to 23hz Link to comment Share on other sites More sharing options...
Torres Posted December 23, 2012 Report Share Posted December 23, 2012 rise is not a constant either. you can't say 'i'm wired to 1 ohm, so rise puts me at 2 ohms'. it does not work like that. and unless it's a burp vehicle, don't even bother trying to mess with it. and stick to the manufacturers RMS ratings Link to comment Share on other sites More sharing options...
Gladski462 Posted January 5, 2013 Report Share Posted January 5, 2013 Instead of all the questions, just buy the system and hook it up. It will work, it will be loud, its DC. Box rise is unavoidable and sucks. EX: My current setup (Mojo 2500 Amplifier) wired to 1 ohm. Rated at 2500rms at 1ohm. Clamped it at full tilt, box rise changed it to 2.2ohms and only put out 2200rms. Not too bad considering it came up to 2.2, but what im getting at is you will almost never get your full rated rms without wiring below 1ohm, which I DO NOT recommend. 08' Grand Cherokee (2) DC Lvl 4 12's Link to comment Share on other sites More sharing options...
TeamHT Posted January 5, 2013 Report Share Posted January 5, 2013 lol Tell me...does this smell like chloroform to you? Link to comment Share on other sites More sharing options...
Cox Posted January 5, 2013 Report Share Posted January 5, 2013 Why did I stumble upon this thread again.... Kenwood Excelon x396AQ2200Fi Q 12XS D3400 XS XP30001/0 RADAFLEXStinger volt meter Mechman 240a alt Link to comment Share on other sites More sharing options...
ChevyBoy95 Posted January 5, 2013 Report Share Posted January 5, 2013 I hate when people bring up box rise speaking about daily systems. Box rise is irrelevant on a daily music system since music is dynamic so the ohm load can be 18ohms 1 second and .2 ohms the next and back up to 12, down to 3, up to 5, down to .3 up to 30, etc. if you aren't talking about a burped tone or a song with a very consistent bassline then why mention box rise? Best Score to Date : 160.5 dB Outlaw (47Hz)[4 XM 15's & 2 Taramps Bass 12k's] BL : http://www.stevemeadedesigns.com/board/topic/147800-chevyboy95s-4-15s-7krms-wall-1533-db-on-half-power/YouTube: http://www.youtube.com/hitemwiththeflex/ Link to comment Share on other sites More sharing options...
will77530 Posted January 5, 2013 Report Share Posted January 5, 2013 bro its simple you dont have the experience to run over rated. unless you want to risk blowing subs and experiment stick to rated power Link to comment Share on other sites More sharing options...
CJ18 Posted January 5, 2013 Report Share Posted January 5, 2013 No need for yall to keep commenting on this dead thread. This guy decided that he is going to buy some cheaper brand subs since "they can handle more". He is no longer a Team DC member either. Link to comment Share on other sites More sharing options...
Recommended Posts