Jump to content

Recommended Posts

Posted

baby jesus would slam that ish

Currently:

2015 Evo X WW

Forgestar F14 18s --Rally Armour Mudflaps

ETS 3.5" FMIC, CAI, Open Dump DownPipe, Test Pipe, Ultimate Racing Catback, BLEVINS TUNE, Fortune Auto 500 Coilovers

Build:

Crescendo Mezzos x2

Crescendo 800.4, 1500.1

Loaded Fi Q12

Second Skin Pro

XS D5100

RF 360.2

Sky High Audio Wiring

Need: ALTERNATOR!

PREVIOUS

1999 Grand Prix GTX

3.8L S/C-few modsWheels: Ruff Racing 280 19x8.5 Sub: Fully Loaded

12" Fi BTL Amps: Autotek MM3000.1d Sundown SAX-100.4HU/Tweets/mids:

Alpine D310 + H701, TBI HDSS tweets, Mpyr audio 65m x4extra sheit:

knukonceptz 0, 4, rcas, speaker wire EA 200amp alt HC 2400

TEAM DEADLY HERTZ!!

Financial Consultant- Charles Schwab

Posted

Those old caddy's are boats! we got a 65 sitting in our back garage right now at work, i'll snap a pic tomorrow at work. HUGE TRUNKS!

-Installer for Duke's Car Stereo

2000 Pontiac Grand Prix - Ported Eaton M90 S/C, 3.5" pulley, XS Power Headers, 1.9 Rockers, FWI, Poly Motor Mounts, Custom Tune.

RF T1000-1bdCP and T400-4

Boston Acoustics SPG 555

Kenwood eXcelon 995

RF Punch 6.5" components and MB Quart Premium 6x9"s

Powermaster Alternator, YellowTop D34, Vmax CT1000

Posted

I live in georgia. If you don't wanna go get it, lemme know, cause I will take it from you if it is too much work for you to come down and get it....:)

2007 Toyota FJ Cruiser Voo Doo Blue

my upgrades and "build" thread.

My Kulicki Box Build

-Alpine 9887 head unit, KTX-100EQ imprint-( sound quality for dummies! ). - MB Quartz 3.5" in back pillars

-Sundown Audio SAX100.4 - JL Audio 3 way 6.5" component set XR653-CSi ( doors and dash )

-JL Audio 2 way Component set XR650CSi

- Alpine MRD - M1005 - Alpine Type - R 12" subs -- 2 - 12" s in a Pete kulicki designed box.

-Alpine High speed Ipod cable, and KCA-SC100 with Sirius sat. radio

-All wiring is Stinger 12 gauge and HPM Level 3 RCAs, KnuKonceptz Kolossus Power and ground and Big done in 1/0,

-270 sq. ft. of Damplifier Pro, 36 sq. ft. of Overkill Pro, 6 full sheets of Luxury Liner, and a gallon of spectrum-

-2 Powermaster D680 Powercells in back

FINALLY !!! I GOT IT METERED ON THE TERMLAB !!! I did a 140.2 at 42 hertz.

Shoehorn, BFH, forklift,duct tape and some zip ties
Posted

It would look insane slammed.....but unless they make a bolt up kit for it....I dont want to screw anything up under there. Id definitely want to restore it.....and trainman, Thanks anyway, but I think Id fly to another country for it. :)

AA-Atomic-Clif Designs-DC-Diamond-Digital Designs-Directed-Eclipse-Fi-Hertz-Hifonics-Kenwood-Memphis-Phoenix Gold-Pioneer-PPI-PSi-Stinger-Sundown-TC Sounds-Viper-Zapco

Posted

Dude, I truely say that I got goosebumps thinking about a caddy like that.. is that nerdy? hahaha I LOVEEEEEEE old caddys Im so jealous.. can't wait to see some pics

1986 C20 Suburban

9 American Bass XFL 15's

B2 M1MKII

14v XS Power Batteries

Maxwell Caps

Acoustical energy is free. Electrical energy is not

you havent lived until you've hit a screw with a router.

Posted

my dad has a 59 cadillac and a 65 gto .. which he (for the GTO) rebuilt the engine entirely by hand with matching #s .. sorry if this is thread jack thought it was relevent

:)

~Matthew

1998 Toyota Camry XLE V6 3L

(1) ScyTek Astra 4000RS-2W-1 2-Way Remote Start Alarm

with Shock and Proximity

(1) 20% Tint All Around (Gately Audio)

(1) 250 Amperage HO Alternator

(1) Big 3 Done In 1/0

(2) Kinetik HC2400 Power Cell

(1) Alpine IVA-D106 Receiver

(1) Peripheral Video Bypass Device

(4) Alpine SPS-17C2 Speakers

(1) Alpine KCE-422i iPod Control Interface

(4) Sheets Dynamat Extreme; for speakers

(1) 10 Square Feet Hushmat (Trunk & Rear Deck)

(4) DC Audio Level 4 15" D2 Subwoofer w/ Level 5 Coils

(1) Wall Built By David, Tuned to 32 Hz

(1) Rockford Fosgate T40001bd Amplifier

(1) Stinger 1/0 Wiring (2 runs of + 2 runs of -)

(1) Stinger Volt Meter

  • 2 months later...
Posted

bringin this post back from the dead.....finally got a hold of pics.....okay, a little more rust than I thought but my ma tells me the interior is mint. can we say, convertible conversion?

Picture001-3.jpg

Picture002-3.jpg

but now I need your guys advice. How would you get it from GA to NY? What I would love is to borrow a flatbed from someone and drive down and get it. If anything I want to go down and see it. NO WAY in hell am I gonna just send a truck to pick it up. My uncles giving this to me. the least I can do is show up to thank him. Anyone know if I can meet the transport there if I have to get it shipped?

AA-Atomic-Clif Designs-DC-Diamond-Digital Designs-Directed-Eclipse-Fi-Hertz-Hifonics-Kenwood-Memphis-Phoenix Gold-Pioneer-PPI-PSi-Stinger-Sundown-TC Sounds-Viper-Zapco

Posted

Looks like you got alot of work to do. I would just hire a professional to move that beast. Get it to a safe place and start the project.

teamsundown-1.jpg

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Recently Browsing   0 members

    • No registered users viewing this page.
  • Who's Online   0 Members, 0 Anonymous, 574 Guests (See full list)

    • There are no registered users currently online
×
×
  • Create New...