Leaderboard

A little update video

Hello everyone, Skar Audio brings you the meanest, loudest, and most powerful 8" Subwoofer we have ever designed with the ZVX-8... This is a behemoth of a subwoofer and rated at a conservative 900 Watts RMS, with the capability of getting extremely loud in a single daily setup or to be used in an array of applicaitons for competition use. The woofer is very responsive and features parameters that allow it to not only get very loud but also sound great while doing so. Engineered with the expectation that customers are going to want to throw everything they can at these stout little monsters, we did the same.. The ZVX-8 features an advanced cooling system that allows it to maintain the best possible temperatures even at the highest power ratings, as well as a competition grade high temperature voice coil for maximum efficiency. MAP Price : $209.99 MSRP Price : $319.99 Available in D2/D4 Voice Coil Configurations Technical Specifications RMS Power : 900 Watts 8" ZVX Competition Level SPL Subwoofer 2.5" High Temperature Voice Coil Triple Stack Ferite Motor Slugs (160mm x3) Competition Grade Paper Cone High Quality Foam Surround Poly Cotton Spider Ultra Low Distortion Design Magnet Weight : 160 Oz Heavy Duty Speaker Push Terminals T/S Parameters (D2/D4) Fs : 45.3 / 44.1 Hz Qms : 3.93 / 3.86 Qes : 0.49 / 0.51 Qts : 0.42 / 0.41 Nref : 0.08 / 0.076 % Bl : 18.9 / 16.6 N/A Spl : 85.2 / 85.3 dB Vas : 5.18 / 5.898 L RMS Power : 900 Watts Enclosure Recommendations Ported : 0.8-1.0 Ft^3 Sealed : 0.9 Ft^3 Displacement : 0.12 Ft^3 Depth : 6.5" Outside Diameter : 8.7" Cut-Out : 7.5" Magnet Diameter : 6.5" Visit SonicElectronix.com or SkarAudio.com to order today! Free Shipping!

So I've been researching into the Z v.4 and I saw that this guy has a 12" on a 3500D @ 1 ohm and @ .5 ohm loads, and the .5 ohm load makes it unreal. So should I get two of these powered by a 3500D v2? Or should I only use one?

Awesome guy to work with!! Hooked me up with a great price on some bus bars!! Polished them up for me and includes bolts and everything! Fast shipping!! Would do business again!!

You should have it to where when the back lid opens you just hear angel like voices over the speakers like you've just opened up the pearly gates! That light definatly sets off the rack back there...lookin great!

Trying out a few UV lights to see what works. Nanometers are important. If you are going to get your own, you should look into something between 385-410nm. I tried these three: i got these at home depot. They worked but it took about 15 minutes. 13watts, Nanmeters unknown. Results were OK but not favorable enough IMO. Next up 20watt flood bulb. Nanometers 365. Didn't work very good at all. Took about 20 min. Next up, the LED panel. Nanometers, 390 (iirc). This one worked pretty good! It took about 5 minutes. Of course the sun takes about less then a minute but for indoor use, 5 minutes aint bad! i am sure there is even better out there but so far, this seems like a good solution for those cloudy days or when you need light in a dark kick panel! check out http://www.blacklight.com to see the panel i bought as well as other stuff too!

I did roll it up at 44hz but the door was open

First time turning it up with music so I wasent sure where to roll it to, Its brutal in there and shook the hell out out my phone camera hahahha

A little update video this is a ALL PICTURE, NO TALK kinda thread - but click here to join the conversation! http://www.stevemeadedesigns.com/board/topic/166901-72-chevelle-system-fix-worst-install-by-a-shop-ever-fiberglass-amptrunkbox-trim-piece-wrapped-53013/page-17 thanks! :D

mr. meade my name is mike and I have been into car audio for a very long time , I started at valley hi car stereo back in 1986 , remember the zapco three piece amps ? yeah that long ago . my ride took first place in sevral of the first IASKA sound off comps. in the late 80's . anyway I have been following your work on you tube for about 2 years and I thought it was about time that I commented on your work . you have really impressed me , you are a true artist sir , you are one of the best I have seen in the industry. so keep it movin BRO. MAD PROPS from a OG bass head . we used to say "CRANK IT OR YANK IT" long live SMD . big mike

Another smooth transaction! Amp is brand new!

Mother of god!!!