hdorre

I bought decals from Mike, and they were sent out the next day. No regrets.. went smooth..

I needed that slow-mo at the end lol

Handbrake ^^

I just know that the first time i used my DD1, i didnt read the directions. I hooked up my neg probe to neg speaker output.. it wouldn't even detect.. Unless something changed? Ill wait for Steve or Tony to chime in.

You're probably reading the directions incorrectly. Sometimes you need to put the pos probe in the neg speaker output The neg probe always goes to gnd

I love mine. Not only is it easy to use, but is accurate!

This is what i did.. just to be safe.

Adding batteries wouldn't solve your problem anyway.

I can't answer all the questions.. But for the max clip question.. Run her wide open.. Just like how you DD1'd your amps.

I use the 30 pin dock connector and the files off of Tonys website. On the iPhone/Pod/Pad/whatever.. Turn off its EQ and soundcheck.. I did some testing and my DD1 had trouble detecting with those on.

Well, Ill tell you that its nice to hear that the owner genuinely cares. I wish I found those a tad earlier. Who knows, I might come back when Im ready to upgrade again.

Please do share. Eh, I feel bad about it.. but whatever you say Jacob.. Thats one of the reasons I didn't pick up a pair.. and went with what I did. I couldn't find many builds with them, or really any info on them.. Now.. With that being said.. I loved the shit out of my SA8s.. For what they are, they definitely pack a punch.. and then some.. and took 2x rms daily perfectly fine. I didn't have any real complaints. Now, if i saw more coverage (in ported boxes) on the X series on the forums.. and the reviews were good.. Id have a pair in my hatch right now.

Whoops.. Didn't see what section this was in.. Ill PM you?

Am I blind, or stupid? I can't find the Neos on the site?

That box is big, tuning is high, and id want more electrical.

Aww, that poor car lol

Damn, I like that resistance For my car, the ground run I upgraded are engine block to chassis, and chassis to battery. You already have a run from batt - to engine block though, right? You should be all set

Meh, I don't see a point. Just don't route the wire stupidly.. This is the only wire I don't have fused..

I was going to say this.. but also check the spiders.. 2 vs 3

Posted too early.. But maybe it killed a cell? Or maybe damaged a few.

Those chargers have a history of overcharging batts iirc.. At "crazy" voltages. That's why I went with CTEK

Psh, Ive revved my Singer to 7200 **Waits for Honda post** But with the OD pulley, its smaller than factory.. and it spins faster than the factory one. It maybe a hunch, but maybe its being overspin. Mechman was worried about that with mine.

Even if they were available, I still wouldn't run one.. Lots of 'em seem to fail.

It tuned my SAZ 3500Dv1 just fine.. 3 times..

What is different about the terminals? I have both S3400 and D3400. Same terminals. Aren't the terminals just reversed? Like in the opposite locations?