Jump to content

Rattling a$$ trunk setups ???


Recommended Posts

Do ALL trunk subwoofer setups rattle like a beee-otch ?!?! I'm sure some of these setups might sound pretty good inside of the vehicle, but nothing sounds lousier than a bunch of sheet metal slapping against itself.

If ever I was going to use my trunk as an enclosure, I think I'd fiberglass it all in, and basically make it sealed... or, if ported, the vents would be come into the cab.

But is it even possible to have a couple strong subwoofers (12"s, or 15"s, or whatever) in an infinite baffle between the trunk and cab with "zero" trunk lid rattling ???

Don't know about you guys, but that would be flat out unacceptable for me.....

Just curious....

Fish

Link to comment
Share on other sites

I had a 1988 Chrysler 5th Ave. Worst rattle ever. To fix it, I rolled up bath towels and stuffed them between the trunk lid and the car. Just put them where the weather trim is and slam it shut HARD. Fixed a lot of the noise. PITA to get the trunk back open though. I think rattle is one of the most annoying things ever, at least try to handle it, ya know/

SMD Super Seller


My Feedback Thread

Link to comment
Share on other sites

Yeah every trunk build that ive heard at least rattled some. When I start my new build I'm sealing off the trunk and bracing it so hopefully it wont rattle much.

And the fact more than one person agrees does not make it a circle jerk, it makes it a bukkake scene and you're in the middle ;)

Chick took 3 shots of Jager, and then, pissed in my mouth..

B5 Passat Build Log

postedimagel.png

Link to comment
Share on other sites

my trunk rattles like a biotch in my monte carlo. i do have a ported box with the port facing the back of the trunk. i tried it facing forward but it was a little quieter in side the car. but i had almost no rattles outside. my next build is gonna be 4 12s and its gonna be tuned to have the port go inside the car. and remove the rattles onn the outside.

2001 Monte carlo 2-Crescendo BC5500 Bass, Crescendo 1600.2 and crescendo 1100.4 mids and highs

clarion-702, 4 ZVX 15s walled, RF 360.3, knukonceptz, toolmaker, DC power 270xp and DC power 370xp alts, PWX mids, FT1 tweets,

Link to comment
Share on other sites

my trunk does pretty damn good without rattling noise i deadened the whole trunk and lid works fine for me. :drinks:

I am forward firing.

12- DC Audio m2Lvl3 12's1- Hertz HSK3 way2- DC5K's2- ZX350.42- Stinger SP1500D batteries in rear3- runs of 1/0ga. to the rearTeam DC Audiodc-banner.jpgdcsoundlab.com

Quality is all in how you take pictures ;) I have plenty of projects that look WAY better on camera then in person :D

crazy to fit so many in so little. Reminds me of some of the porns I've seen?

Link to comment
Share on other sites

I fixed 99% of the trunk lid rattle on my car. A couple feet of deadener and a couple cans of foam is all it took.

Now I have to lay some deadener on the floor to get rid of the rest of the rattle.

But I swear the trunk lid is dead quiet, even with a factory spoiler.

I'll take some vids when I get the floor deadened.

2005 Subaru Outback Wagon Pioneer 9400BH Fi Q 15, SAZ1500dV3

The first build>>> http://www.stevemead...-outback-build/

140.9 @ 36hz Sealed on dash!

REBUILT!!! 2 Fi Q 15s, 2 SAZ1500dv3 146.9 @ 39hz dBDRA certified

Link to comment
Share on other sites

for the most part, any trunk that has woofers firing back will have trunk rattle, basically at all times... any trunks that are firing forward sealed off with have little to non

ive had both firing back and firing in, when i was firing in i had none at all, just a few things on the bottom of the car rattled, now that i went back to firing back.. EVERYTHING rattles

Team Sundown Audio

**CURRENT** -- 2012 Scion tC Build Click Here

**OLD** -- 2002 Pontiac Grand AM Build Click Here
check them out, slap me a comment

2002 Pontiac Grand AM SE 2.2l 4 cylinder ecotec.
-------------------------------------------------------------------

Head Unit - Alpine CDA-9887
Subs - 2x Z 12 v.2s - v.3 + NS Soft parts
Amplifier - Sundown Audio SAZ-3500D
Enclosure - 3.33 Cubes tuned to 34.66hz
Front Stage - JBL P660c 6.5" Components
Rear Deck - Powerbass 4xl 6.5" Mid-Range
Front Stage Amplifier - Sundown Audio SAX-100.4D
Wires - Kicker Hyperflex 1/0, KnuKonceptz 1/0, Knu 4 and 8 Gauge, Kicker RCAs
Electrical - 275 AMP DC Power H/O Alternator, XS Power S3400, XS Power D2700
Videos - http://www.youtube.com/user/BeAILsTaR13
-------------------------------------------------------------------

Link to comment
Share on other sites

Never heard a trunk setup that didn't rattle some.

I dont have any. :shrug:

THERE IS NO BUILD LOG!

1998 Chevy Silverado ext cab

Alpine CDA-9887

4 Team Fi 15s

2 Ampere Audio TFE 8.0

2 Ampere Audio 150.4

3 Digital Designs CS6.5 component sets

Dual Mechman 370XP Elite alternators inbound!

8 XS Power d3400

6 XS power d680

Second Skin

Stinger

Tsunami Wiring

Sky High

A Real Voltmeter not a piece of shit stinger.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Recently Browsing   0 members

    • No registered users viewing this page.
  • Who's Online   0 Members, 0 Anonymous, 351 Guests (See full list)

    • There are no registered users currently online
×
×
  • Create New...