Jump to content
Second Skin Audio

Fi SP4 subwoofer enclosure sizes?!?!?!?


drumstar7

Recommended Posts

I am doing away with my 4x12 setup and going to a 2x18 setup with Fi sp4's. I plan on running one Crescendo BC 5500 on each subwoofer wired down to a single ohm on each amp.(not strapped.) I wanted to build a custom dual chambered ported box for this setup and so far I have a few ideas of my own but am very unsure if it will give me the most spl and output!!! I can go 48Wx32Hx28L maybe even 33H

39.5x31 face
48x28 top
48x28 bottom
27x31x27x31 port L
26x31x26x31 right
48x31 back
22.5x31x22.5x31 tuned to around 30hz and 32ish after sub displacement.. 8Cubes per sub. too big or? I open for Ideas, I have plenty of power for the amplifiers MM Elite 370 and three HC1800, 60 feet of 1/0 RF OFC
Link to comment
Share on other sites

Maybe a single 5500 if that per sub. They are underrated at 3000 wrms and putting almost x4 the power is not a good idea.

2001 Saturn L200
-Sony MEX-BT4100P
FRONT STAGE:
- (4) Crescendo PWX 6
- Cadence XA250.2
SUB STAGE:
-Fi Audio BL 15 (Sealed Off)
-Crescendo BC2k
ELECTRICAL:
- Singer 240A alt

- XS Power D3400
- SkyHigh OFC power/speaker wire
- Big 3 with SkyHigh 0gauge
Build Log: Click Here

Scores: 146.5db @ 29hz Outlaw

Link to comment
Share on other sites

Where do we start?

-Sub thermal and mechanical power handling

-That enclosure idea

-Your subpar electrical setup

On 5/8/2011 at 7:38 PM, Kranny said:
On 5/8/2011 at 7:35 PM, 'Maxim' said:

It hurts me inside when I read stuff like this and remember you're 15

LMFAO so true

:blush:

Mitsubishi 3000GT (Old Build)

Headunit: Pioneer 80PRS

Frontstage: (2) McLaren Audio MLT-2 Tweeters & (4) PRV Audio MR Series Neo 6.5" Mids

Substage: 4 15" Hybrid Subs - Tantric Motors & Sundown Softies

Amps: Banda 2.4D Amp (Tweets), American Bass VFL 350.4 (Mids), and (2) Ampere 3800s

Electrical :Singer 260A Alt & JY Power Lithium

 

2005 Chevy Colorado Ext Cab

Headunit: Pioneer 80PRS

Frontstage: 4 PRV 700Ti Tweets & 6 10" Delta Mids on 3000wrms

Substage: 6 Fi BTL 18s in a 4th Order Walkthrough on 3 Wolfram 4500s

Electrical: Singer "390" and JY Power

My Official Feedback Thread

Link to comment
Share on other sites

I'm confused are you putting a 5500 on each sub or two 5500s PER sub. The way you've worded it shows you're throwing 11k rms to each sub.

Syphlyns 2000 F150 4.6L V8

H/U: Kendwood KDC-X898

Speakers: 4 x Alpine SPR-68 Speakers

4 Channel Amp: Alpine PDX-F4

Sub: Sundown Zv4 12

Sub Amp: Sundown SAZ-2000D

Box: 2.75 Cu Ft @ 31Hz

Alternator: Mechman 250A elite series

Wiring: All KnuKoncepz 0 gauge OFC + KnuKonceptz Krystal RCAs

Link to comment
Share on other sites

Look one BC 5500 per sub is not going to hurt anything, I want to run it less than half power. In the sense clean power no clipping from amps or subs. Also these amplifiers have no fans and at one ohm half power it would be less heat. I just need some enclosure ideas and I also was leaning toward 8cubes of airspace. I was told these subs do great in larger boxes.

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...