Jump to content


S.O.T.M. Winner
  • Posts

  • Joined

  • Last visited

  • Days Won


Everything posted by OrionStang

  1. Was sarcasm Im thinking somebody bullied him, so he did this to scare them.
  2. I get good deals from Maximum Motorsports through my installer. Mounts to the strongest part of the car, not the floorboard. The two rear tubes will be custom fit. Not sure on the labor, but likely around 6-650 for the kit. http://www.maximummotorsports.com/Drag-Race-6-point-Mustang-Roll-Bar-E-Z-Remove-door-bars-fixed-harness-mount-2005-2014-hardtop-P1403.aspx
  3. Of course, but Im thinking if a stray spark goes under there. How quickly can it go up? LOL Guess I could try to pull a sizable piece and do some experimenting.
  4. I know this stuff is flammable, but how worried do I need to be about sparks from welding catching it on fire. Already started the tedious task of cleaning the area's where the cage will mount, and obviously will have blankets down. There will be an extinguisher nearby, but would rather not have to use it. Thoughts? Experience?
  5. LOL. Define excessive. Im sure temps inside my car are 150+ in the summer. Probably more on the sheet metal in the sun, ie quarter panels. Solid as fuck still.
  6. Interesting http://www.popularmechanics.com/cars/trucks/a20310/european-platooning-challenge-self-driving-trucks-1000-miles/
  7. If that's not photoshopped, its a damn clean swap. Ugly, but clean LOL
  8. How cold is cold? I've applied it in the 50s, just clean the area well. It is a bit more difficult to into corners and on curved surfaces, since its less flexible. Mine's still there almost 7 years later, and ain't coming off LOL
  9. Can't decide whether to sell the P99 or not. Everything else is gone, might as well, right?

    1. Show previous comments  5 more
    2. ToNasty


      Put it in the car. Then it won't be sitting

    3. Kyblack76


      Wish I could get it from ya

    4. Soccerballzs


      Keep it it is the Holy Grail of HU's.

  10. I don't run Mechman, but on my alt, we switched the pulley back to the stock clutched unit and eliminated slip/squeal. Ninja'd-LOL^
  11. Hopefully Rusty will see this and chime in. Also, there's the "protoype" part. Id offer 400 LOL
  12. The bottom plate doesn't even look DC, looking at the motors on their site.
  • Create New...